WALL MOUNT FIREPLACE MODEL #RD-S RD-C CAUTION – FOR YOUR SAFETY Questions about installation, operation, or troublesho
10 4. Remove hex plug from liquid propane inlet of regulator and install into NG inlet of regulator; use thread sealant to assure there are no lea
11 WARNING: Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Corr
12 INSTALLATION Continued Marking Screw Locations: 1. Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is
13 OPERATING FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result c
14 OPERATING Continued Note: If pilot goes out, repeat steps 3 through 8. This heater has a safety interlock system. Wait one (1) minute before l
15 CLEANING AND MAINTENANCE WARNING: Turn off heater and let cool before servicing. CAUTION: You must keep control areas, burner, and circulatin
16 TROUBLESHOOTING Continued OBSERVED PROBLEM PROBABLE CAUSE REMEDY When ignitor button is pressed in, there is no spark at ODS/pilot 1. Ig
17 TROUBLESHOOTING Continued OBSERVED PROBLEM PROBABLE CAUSE REMEDY Burner backfiring during combustion. 1. Burner orifice is cl
18 REPLACEMENT PARTS NOTE: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty. PARTS
19 PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Par
2 TABLE OF CONTENTS Important Safety Information...
20 PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts
3 IMPORTANT SAFETY INFORMATION IMPORTANT: Read this owner’s manual carefully and completely before trying to assemble, operate, or service this hea
4 6. This heater needs fresh air ventilation to run properly. This heater has an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS shut
5 UNPACKING 1. Remove top inner pack 2. Tilt carton so that fireplace is upright. 3. Remove protective side packaging. 4. Slide fireplace out o
6 Unusually tight construction is defined as construction where: a) walls and ceilings exposed to the outside atmosphere have a continuous water va
7 Ventilation Air From Inside Building This fresh air would come from adjoining unconfined space. When ventilating to an adjoining unconfined space,
8 CLEARANCES TO COMBUSTIBLES Carefully follow the instructions below. This fireplace is a wall mount unit designed to mount directly on a wall. I
9 INSTALLATION Continued CAUTION: Use only new black iron or steel pipe. Internally tinned copper tubing may be used in certain areas. Check your
Comments to this Manuals