Procom ML170EPC Installation Manual download pdf (Page 8)

8

INSTALLATION

continued

Methods For Attaching Mounting

Bracket To Wall

Only use last hole on each end

of mounting bracket to attach

bracket to wall. These two holes

are 16 inches apart from their

centers. Attach mounting

bracket to wall only in one of two

ways:

1. Attaching to wall stud

2. Attaching to wall anchor

Attaching to Wall Anchor: This

method allows you to attach

mounting bracket to hollow walls

(wall areas between studs) or to

solid walls (concrete or masonry).

Decide which method better

suits your needs. Either method

will provide a secure hold for the

mounting bracket.

2. Mark screw locations on

wall. (see Figure 6)

Note: Only mark last hole on

each end of mounting bracket.

Insert mounting screws through

these holes only.

3. Remove tape and mounting

bracket from wall.

Marking Screw Locations

1. Tape mounting bracket to wall

where heater will be located. Make

sure mounting bracket is level.

Attaching to Wall Stud Method

For attaching mounting bracket to

wall studs

1. Drill holes at marked locations

using 9/64" drill bit.

2. Place mounting bracket onto

wall. Line up last hole on each

end of bracket with holes drilled

in wall.

3. Insert mounting screws through

bracket and into wall studs.

4. Tighten screws until mounting

bracket is firmly fastened to

wall studs.

Attaching to Wall Anchor Method

For attaching mounting bracket to

hollow walls (wall areas between

studs) or solid walls (concrete or

masonry)

1. Drill holes at marked locations

using 5/16" drill bit. For solid

walls (concrete or masonry), drill

at least 1" deep.

2. Fold wall anchor as shown in

Figure 7 below.

Figure 7- Folding Anchor

3. Insert wall anchor (wings

first) into hole. Tap anchor

flush to wall.

4. For thin walls (1/2" or less),

insert red key into wall

anchor. Push red key to

"pop" open anchor wings

(see Figure 8).

Model ML170EPC ML170EHPC

Figure 6 - Mounting Bracket

Clearances

Model ML250EPC ML250EHPC

Figure 8 - Popping Open Anchor

Wing For Thin Walls

IMPORTANT: Do not hammer

key! For thick walls (over 1/2"

thick) or solid walls, do not pop

open wings.

5. Place mounting bracket onto

wall. Line up last hole on

each end of bracket with wall

anchors.

6. Insert mounting screws through

bracket and into wall anchors.

7. Tighten screws until mounting

bracket is firmly fastened to wall.

Placing Heater on Mounting

Bracket

1. Locate two horizontal slots on

back panel of heater (see

Figure 9).

2. Place heater onto mounting

bracket. Slide horizontal slots

onto stand-out tabs on

mounting bracket.

Note: Wall anchors, mounting

screws are in hardware

package. The hardware package

is provided with heater.

Attaching to Wall Stud: This

method provides the strongest

hold. Insert mounting screws

through mounting bracket and

into wall studs.

WARNING: Maintain

minimum clearances shown in

Figure 6. If you can, provide

greater clearances from floor

and joining wall.

Figure 9 - Mounting Heater Onto

Mounting Bracket

Floor

Only Insert Mounting

Screws Through

Last Hole On Each

End

Adjoining Wall

Floor

Only Insert Mounting

Screws Through

Last Hole On Each

End

Adjoining Wall

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments