Procom MN060HBA User Manual download pdf (Page 11)

11

Figure 16-2 - Control Knob in The

OFF Position

(MN100HBA&MN100TBA)

Figure 17 - Pilot

OPERATING YOUR HEATER

Manual Control Models

nLIGHTINGn

INSTRUCTIONS

1. STOP! Read the safety

information on the side of

heater.

2. Check that gas supply to

heater is on.

3. Push in gas control knob

slightly and turn clockwise to

the OFF position.

4. Wait five (5) minutes to clear

out any air. Then smell for

gas, including near the floor.

If you smell gas, STOP!

Follow “B” in the safety

information on the side of the

heater. If you do not smell

gas, go to the next step.

5. Push in gas control knob

slightly and turn

counterclockwise to

“PILOT/IGN” and depress for

five(5) seconds

NOTE: The first time that the

heater is operated after

connecting the gas supply , the

control knob should be depressed

for about thirty (30) seconds. This

will allow air to bleed from the gas

system.

6. With control knob pressed in,

push down and release the

ignitor button. This will light

pilot. If needed, keep pressing

ignitor button until pilot lights.

7. Keep control knob depressed

for ten (10) seconds after

lighting pilot. If pilot goes out,

repeat steps 5,6 and 7.

8. To select the desired heating

level, partially press down the

control knob slightly and rotate

counterclockwise . Release the

downward pressure on the knob

while continuing to turn until the

knob locks at the desired setting

position. Do not operate

between locked positions.

l Set control knob to desired

heating position.

NOTE: Both HIGH and LOW

are locked positions. You

must press in control knob

before turning it from these

positions.

nTO TURN OFFn

GAS TO APPLIANCE

Shutting Off Heater

1. Turn control knob clockwise

to the OFF position.

2. Turn off all electric power to

the appliance if service is to

be performed.

Shutting Off Burner Only

(Pilot Stays Lit)

Turn control knob clockwise

to the PILOT/IGN position.

nMANUAL LIGHTINGn

PROCEDURE

1. Remove lower front panel(see

Figure 7 page 7).

2. Follow steps 1 through 5

under Lighting Instructions.

3. With control knob pressed in,

strike match. Hold match to

pilot until pilot lights.

4. Keep control knob pressed in

for 30 seconds after lighting

pilot. After 30 seconds, release

control knob. Follow step 8

under Lighting Instructions.

5. Replace lower front panel.

CAUTION: Do not try to

adjust heating levels by using

the equipment shutoff valve.

Figure 16 -1- Control Knob In

The OFF Position (MN060HBA)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments