Procom MD100TBA Installation Manual download pdf (Page 11)

www.usaprocom.com

11200000-01B

LOCATING HEATER

Figure 5 - Mounting Bracket Location

Removing Front Panel of Heater

1. Remove two screws near bottom corners

of lower front panel.

2. Pull bottom of lower front panel forward,

then down (see Figure 6).

INSTALLATION

Figure 6 - Removing Front Panel Of

Heater

Methods For Attaching Mounting

Bracket To Wall

Use only the last hole on each end of mount-

ing bracket to attach bracket to wall. Attach

mounting bracket to a wall only in one of two

ways:

Mounting Bracket

This heater is designed to be mounted on a

wall. For convenience and efciency, install

heater:

1. Where there is easy access for operation,

inspection, and service.

2. In the coldest part of room.

FASTENING HEATER TO WALL

Mounting Bracket

The mounting bracket is located on back panel

of heater (see Figure 5). It has been taped

there for shipping. Remove mounting bracket

from back panel.

1. Attaching to wall stud: This method pro-

vides the strongest hold. Insert mounting

screws through mounting bracket and into

wall studs.

2. Attaching to wall anchor: This method

allows you to attach mounting bracket to

hollow walls (wall areas between studs)

or to solid walls (concrete or masonry).

Decide which method better suits your needs.

Either method will provide a secure hold for

the mounting bracket.

Marking Screw Locations

1. Tape mounting bracket to wall where

heater will be located. Make sure mount-

ing bracket is level.

WARNING: Maintain minimum

clearances shown in Figure

4, page 10. If you can, provide

greater clearances from oor and

joining wall.

2. Mark screw locations on wall (see Figure

7, page 12).

Note: Mark only last hole on each end of

mounting bracket. Insert mounting screws

through these holes only.

3. Remove tape and mounting bracket from

wall.

Attaching Mounting Bracket To Wall

Note: Wall anchors, mounting screws, and

spacers are in hardware package. The hard-

ware package is provided with heater.

Attaching to Wall Stud Method

For attaching mounting bracket to wall studs:

1. Drill holes at marked locations using 9/64"

drill bit.

2. Place mounting bracket onto wall. Line

up last hole on each end of bracket with

holes drilled in wall.

3. Insert mounting screws through bracket

and into wall studs.

4. Tighten screws until mounting bracket is

rmly fastened to wall studs.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

Comments to this Manuals

No comments