Procom MD100TBA Installation Manual download pdf (Page 18)

www.usaprocom.com

200000-01B18

Figure 19 - Control Knob in the OFF

Position

1. STOP! Read the safety information above.

2. Make sure equipment shutoff valve is fully

open.

3. Turn control knob clockwise to the

OFF position.

4. Wait ve (5) minutes to clear out any air.

Then smell for gas, including near the

oor. If you smell gas, STOP! Follow "B"

in the safety information above. If you do

not smell gas, go to the next step.

5. Turn control knob counterclockwise

to the PILOT position. Press in control

knob for ve (5) seconds (see Figure 19).

Note: The rst time that the heater is oper-

ated after connecting the gas supply,the

control knob should be pressed for about

thirty (30) seconds. This will allow air to

bleed from the gas system. If pilot does

not stay lit, refer to Troubleshooting, pages

23 though 25. Also contact a qualied

service technician or gas supplier for

repairs. Until repairs are made, light pilot

with match.

• If control knob does not pop up when

released, contact a qualified service

technician or gas supplier for repairs.

6. With control knob pressed in, push

down and release ignitor button. This

will light pilot. The pilot is attached to

the front of burner. The pilot can be

seen through the grill. If needed, keep

pressing ignitor button until pilot lights.

Note: If pilot does not stay lit, refer to

Troubleshooting, pages 23 though 25.

Also contact a qualied service technician

or gas supplier for repairs. Until repairs

are made, light pilot with match. To light

pilot with match, see Manual Lighting

Procedure, page 20.

7. Keep control knob pressed in for 30

seconds after lighting pilot. After 30

seconds, release control knob. If control

knob does not pop up when released,

contact a qualied service technician or

gas supplier for repairs.

MODELS MD100TBA, MD200TBA, MD300TBA, MD200TBA-BB AND

MD300TBA-BB

LIGHTING INSTRUCTIONS

Ignitor Button

Control Knob

OPERATION

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly, a

re or explosion may result caus-

ing property damage, personal

injury or loss of life.

A. This appliance has a pilot which must

be lighted by hand. When lighting the

pilot, follow these instructions exactly.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell

next to the oor because some gas is

heavier than air and will settle on the oor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do

not use any phone in your building.

• Immediately call your gas supplier

from a neighbor’s phone. Follow the

gas supplier’s instructions.

• If you cannot reach your gas supplier,

call the re department.

C. Use only your hand to push in or turn

the gas control knob. Never use tools.

If the knob will not push in or turn by

hand, don’t try to repair it, call a qualied

service technician. Force or attempted

repair may result in a re or explosion.

D. Do not use this appliance if any part

has been under water. Immediately call

a qualied service technician to inspect

the appliance and to replace any part of

the control system and any gas control

which has been under water.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 75 76

Comments to this Manuals

No comments