Procom MD100TBA Installation Manual download pdf (Page 13)

www.usaprocom.com

13200000-01B

Side View

Front View

INSTALLATION

Figure 11 - Installing Bottom Mounting

Screws

Installing Bottom Mounting Bracket

1. Install bottom bracket to heater bottom

with two screws. It may be more conve-

nient to remove heater from wall bracket

to attach.

2. Place heater on wall mounting bracket.

3. Mark screw locations on wall.

4. Remove heater from mounting bracket.

5. If installing bottom mounting screws into

hollow or solid wall, install wall anchors.

Follow steps 1 through 4 under Attaching

To Wall Anchor Method, page 12. If install-

ing bottom mounting screw into wall stud,

drill holes at marked locations using 9/64"

drill bit.

6. Replace heater onto mounting bracket.

7. Place spacers between bottom mounting

holes and wall anchor or drilled hole.

8. Hold spacer in place with one hand. With

other hand, insert mounting screw though

bottom mounting hole and spacer. Place

tip of screw in opening of wall anchor or

drilled hole.

9. Tighten both screws until heater is rmly

secured to wall. Do not over tighten.

Wall

Spacer

Heater

Note: Do not replace front panel at this time.

Replace front panel after making gas connec-

tions and checking for leaks.

This appliance is factory

preset for propane/LP gas.

No changes are required for

connecting to propane/LP.

Only a qualified installer or

service technician can perform

gas selection and connecting to

gas supply.

CAUTION: Two gas line in-

stallations at the same time are

prohibited. The access plate

to the simple switching means

shall not be opened while the

heater is in operation.

GAS SELECTION

CAUTION: To avoid gas

leakage at the inlet of regulator,

a qualied installer or service

technician must use supplied

hex plug with sealant.

WARNING: Do not attempt to

access or change the setting of

the fuel selection means.

Access to and adjustment of the fuel selection

means must only be performed by a qualied

service person when connecting this appliance to

a specied fuel supply at the time of installation.

Change of the selector setting to other than

the fuel type specied at the time of installa-

tion could damage this appliance and render

it inoperable.

The installer shall replace the access cover

before completing the installation and operat-

ing this appliance.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

Comments to this Manuals

No comments