Procom MD100TBA Installation Manual download pdf (Page 12)

www.usaprocom.com

200000-01B12

INSTALLATION

12

1

/8"

14

1

/2"

Min.

6

3

/4"

Min.

Adjoining Wall

Only Insert Mounting

Screws Through Last

Hole On Each End

Floor

10

5

/

8

"

Min.

17

3

/

8

"

18

1

/

2

"

Min.

Only Insert Mounting

Screws Through Last

Hole On Each End

Floor

Adjoining Wall

Figure 7 - Mounting Bracket Clearances

Models: MD100TBA & MD100HBA

Models:

MD200TBA, MD300TBA

MD200TBA-BB, MD300TBA-BB

Figure 10 - Mounting Heater Onto

Mounting Bracket

Mounting

Bracket

(attached

to wall)

Horizontal Slots

Stand-Out Tab

Figure 8 - Folding Anchor

Figure 9 - Popping Open Anchor Wings

For Thin Walls

Placing Heater On Mounting

Bracket

1. Locate two horizontal slots on back panel

of heater (see Figure 10).

2. Place heater onto mounting bracket. Slide

horizontal slots onto stand-out tabs on

mounting bracket.

Attaching to Wall Anchor Method

For attaching mounting bracket to hollow

walls (wall areas between studs) or solid walls

(concrete or masonry):

1. Drill holes at marked locations using

5/16" drill bit. For solid walls (concrete or

masonry), drill at least 1" deep.

2. Fold wall anchor as shown in Figure 8.

3. Insert wall anchor (wings rst) into hole.

Tap anchor ush to wall.

4. For thin walls (1/2" or less), insert red key

into wall anchor. Push red key to “pop”

open anchor wings (see Figure 9).

IMPORTANT: Do not hammer anchor key! For

thick walls (over 1/2" thick) or solid walls, do

not pop open wings.

5. Place mounting bracket onto wall. Line up

last hole on each end of bracket with wall

anchors.

6. Insert mounting screws through bracket

and into wall anchors.

7. Tighten screws until mounting bracket is

rmly fastened to wall.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

Comments to this Manuals

No comments